Standards & References

A control panel is only as trustworthy as the documentation behind it. Everywhere on this site we state that a panel is built to a standard, that standard is a real, published document maintained by a recognized standards body, not a marketing phrase. This page names each one, credits its publisher, and links to the source so an engineer, inspector, or insurance reviewer can verify the claim independently.

If you need a specific clause, edition, or a copy of the documentation package for a panel we built, ask and we will point you to it.

STANDARDS REFERENCED ON THIS SITE

Cited as: designation: title. Publisher. Source. Standards are revised on their own cycles; always confirm the edition that applies to your jurisdiction and project.

UL 508A: Standard for Industrial Control Panels. UL Solutions. ul.com

NFPA 70, Article 409: National Electrical Code: Industrial Control Panels (short-circuit current rating and marking). National Fire Protection Association. nfpa.org

NFPA 79: Electrical Standard for Industrial Machinery. National Fire Protection Association. nfpa.org

IEC 60204-1: Safety of Machinery: Electrical Equipment of Machines, Part 1: General Requirements. International Electrotechnical Commission. iec.ch

NEMA ICS 1-2022: Industrial Control and Systems: General Requirements. National Electrical Manufacturers Association. nema.org

29 CFR 1910, Subpart S: Occupational Safety and Health Standards: Electrical. U.S. Department of Labor, Occupational Safety and Health Administration. osha.gov

ANSI: American National Standards, as referenced by the standards above. American National Standards Institute. ansi.org

ISA: Automation and control system standards and practices. International Society of Automation. isa.org

CERTIFICATION

Integrated Component Solutions LLC is a UL 508A certified panel shop. Panels we fabricate carry the UL listing mark, with the short-circuit current rating calculated and marked in accordance with NFPA 70 Article 409. As-built drawings and component datasheets are available on request for code inspectors and authorities having jurisdiction.

PHOTOGRAPHY

Every photograph on this site was taken at our facility at 8044 118th Ave N, Largo, Florida, and shows our own shop, equipment, panels, and project work. No stock photography or third-party imagery is used, and no customer site is shown without permission.

TRADEMARKS

Product and company names used on this site are the trademarks or registered trademarks of their respective holders. Naming them describes the equipment we work on; it does not imply endorsement, affiliation, or authorized-distributor status.

Allen-Bradley, PanelView, ControlLogix, RSLogix, PowerFlex and FactoryTalk are trademarks of Rockwell Automation, Inc. TIA Portal and SIMATIC are trademarks of Siemens AG. TwinCAT is a trademark of Beckhoff Automation GmbH & Co. KG. InTouch and Wonderware are trademarks of AVEVA Group. SOLIDWORKS is a trademark of Dassault Systèmes. Yaskawa, ABB, Danfoss, Omron, Eaton, Unitronics, Crouzet, Maple Systems, Red Lion, Modicon, GE and Square D are trademarks of their respective owners.

QUESTIONS

If you have a standards question about a panel in your plant, send us a photo of the nameplate and we will tell you what it is marked for, and what it would take to bring it current. Request a Retrofit Assessment, or call 727-221-9368.